What makes a good fitting room? If you have 3 Saudi Arabia coins on the last row of a page, and you get 2 new ones you need to add, it is sometimes easier to start a whole new page (and maybe move all the Saudi Arabia coins to it) instead of shifting everything on the next page to make room for one new coin. Let’s say that you have a 1937 and a 1948 3-pence coin, and you’re trying to decide which to keep and which to trade. If you have a way of reviewing mintage numbers, then for a particular KM it’s usually better to collect the year that has the smallest mintage – but keep in mind that low mintage doesn’t always mean higher value. Nicotine pouches have gained popularity and have indeed been the subject of news and discussions in recent years. Condition. Having a coin that is in better condition is usually more important than having one that’s a few years older. It’s a means to an end, nothing more.
A coin from a year with a lower mintage can be slightly more valuable than from a year with a higher mintage because it means there were fewer of those coins made. Is it better to collect older or newer coins for a specific KM number? KM numbers are a coin numbering standard created by the Standard Catalog of World Coins, where each different coin for each country gets a number. I find that most of the world coins I collect will fit correctly in either a quarter-sized flip or tote bags supplier a half-dollar-sized flip. But you don’t have to have every size of flip listed above (for example, any coin that would fit in a dime-sized flip would fit just as well in a penny-sized flip). Value. If you have access to a coin catalog like the Standard Catalog of World Coins, then you should also consider the coin’s estimated value when determining which coin you should keep. If there is a significant difference in the quality of the 2 coins, the better-looking coin is probably the one you should keep. I like the way the binder pages display coins, so I’m willing to put in the time to keep it organized.
If you put a coin in the folded flip, it can be seen from both sides but will be covered, and protected, by the plastic film. Flips are usually available in 3 different sizes – 1.5×1.5, 2×2, or 2.5×2.5. These represent the width and height, in inches, of the flip when it is folded (remember, they start as a rectangle, but you fold them in half to store a coin). Each half of the flip has a hole, or window, in the cardboard (but not in the plastic), and they line up so that when folded in half, you can see all the way through the flip. The flip folds in half, forming a square, with the plastic on the inside. I like paper flips because they are inexpensive (usually less than 10 cents each), and because I can write directly on the flip. What are Paper Coin Flips? Paper flips are very easy to use, but using them correctly requires a little practice. In my experience, 2×2 flips and pocket pages are the most common. So if you’re not sure what you should get, start with 2×2 flips and pages. All binder pocket pages should have openings in the top (or sometimes on the side) to slide your flips into.
And while some real-life TV dramas last decades, most have shorter shelf lives. Just attach your binder clip to one of your last pages or dividers (should be something sturdy), and clip in your favorite pen or highlighter! This cutout is used for pushing a flip out of a pocket so that it is easier to grasp and remove, and it is a definite time- and finger-saver when you need to shift coins around in your pages. Some also have a small cutout (sometimes called a “thumb-cut”) on the opposite side of each pocket. Wait until you have several coins to add. Because it takes time to shift coins around in binder pages, you might want to wait until you have several coins that need to be added before tackling the job. For example if you wait until you have 3 coins from Japan to add, you only have to do the shifting once. For our example coins, the mintage for the 1937 3-pence coin was 45 million and for the 1948 is only 5 million, so there are 1/9th as many 1948s as 1937s. In reviewing the mintage information in the Standard Catalog of World Coins, it’s been my experience that the first year of a new design – in our example, the 1937 3-pence coin – often has a very high mintage compared to the years after, so it is often less desirable to have the first coin of a new design.
